FileManager server

This section contains the steps for the installation and configuration of the FileManager server to be used to redirect the SE Capture server.

All the procedures below must be executed on a Windows server, on which File Manager will be installed, not on the SE Suite server.

FileManager installation

The installer must be requested from SoftExpert support or copied from the "Plugins" folder in the SoftExpert Suite server.

1.When executing the installer, the user will be requested to select the database_config.xml file in the environment.

2.This file must be copied from the /usr/local/se/conf folder in the SoftExpert Suite server.

3.Select it and continue with the installation until it is finished:

1 / 3

2 / 3

3 / 3

❮ ❯

4.After finishing the installation, it is necessary to restart the Apache Tomcat service:

filemanager_server-2

1.Access SoftExpert Document Configuration General parameters Services.

2.Check the Enable SE Capture service redirection option.

3.In the Server field, enter the full application address. For example: http://<IP IN WHICH THE APPLICATION IS BEING EXECUTED>

4.In the Port field, enter the port in which the Tomcat service is being executed.

5.Then, test the entered values through the Save button next to the Port field.

6.By clicking on the button, the "Successful connection" message will be displayed.

7.Save the changes through the Save button in the general parameters, thus finishing the service installation and configuration.